The DistroCase™ 350P Mid Tower Chassis is a fully modular chassis with a distro plate as the chassis’ main body made with SPCC & PMMA. This multi-functional PC enclosure is incorporated with its own water channels, reservoir (about 800ml coolant), a preinstalled D5 pump, and multiple inlets and outlets. The 48 LEDs on the DistroCase™ 350P Mid Tower Chassis are TT RGB PLUS and NeonMaker Light Editing Software compatible. Other than that, users also have an option to control the lights by synchronizing the case with motherboards including ASUS Aura Sync, GIGABYTE RGB Fusion, MSI Mystic Light Sync, and ASRock Polychrome. The DistroCase™ 350P Mid Tower Chassis provides users, gamers, and enthusiasts with an easier way to design their water loops for the ultimate user experience.
Designed to synchronize with ASUS Aura Sync, GIGABYTE RGB Fusion, MSI Mystic Light Sync and ASRock Polychrome. It supports motherboards that have a 5V addressable RGB header, allowing you to control the lights directly from the above-mentioned software without installing any extra lighting software or controllers. For more details, please visit ASUS, GIGABYTE, MSI and ASRock official websites.
Thermaltake designs the open frame panoramic viewing chassis as anyone can access and do his/her
own mods as well as print out his/her own ideas using available liquid cooling components and manuals
Users can download 3D printing accessory files on the 3D Makers Microsite, and print them out to do a special mod.
The DistroCase™ 350P features one 5mm thick tempered glass panel which is designed to meet the highest standards in the industry. The enlarged glass windows permit users to fully display every RGB component in the system, and show off their dedication and skill sets.
|PURE FAN Series||●||●||–|
|Riing FAN Series||●||●||–|
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop setup
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.